The W Series Blastroom utilises a unique pneumatic recovery floor system to recover blasted abrasive. The advantage of this recovery floor system is only a very shallow pit is required and the floor is extremely strong allowing rail tracks to run directly over the top of it and not requiring special concrete foundations.
The room is suitable for use with most commonly available recyclable abrasive types, ie steel grit, aluminium oxide, glass beads, ceramic beads, stainless steel shot, cut wire etc. The equipment is designed to permit quick and easy clean out to change to other abrasive types if required.
The W Series floor is used to both ventilate the blastroom and recover the spent abrasive media simultaneously. The system operates on the principle of vertical downdraught ventilation air movement, to immediately capture dust and abrasive. This highly efficient down draught ventilation technique provides excellent visibility, increases productivity and ensures surrounding areas and operators are not subjected to nuisance dust and abrasive particles. The abrasive recovery and blastroom ventilation airflow are generated through a high efficiency TDF dust collector.
The low profile height of the floor modules permits the W Series blast room to be located directly onto a flat concrete floor. If the blastroom floor level is required to be flush with the surrounding factory floor level the entire blastroom can be situated into a pit approx. 275mm deep.
tel: +65 6505 9098
fax: +65 6245 8785
mobile: +65 9850 0121
sales@blastechnik.com
Blastechnik Pte Ltd
10 Admiralty Street #02-69
North Link Building, Singapore 757695